Bill-Tek Electronics
Product Information Page
- Simple Elevon Mixer
- (Now Shipping)
- This product is designed for the "flying wing" like a Zagi or Razer. It is a microprocessor controlled elevon mixer giving 100% mix of elevator and aileron.
- Simple Elevon Mixer Kit
- (Now Shipping)
- Same as above, except un-assembled. You should have some experience building electronic kits, but as long as you have an appropriate soldering iron for electronics, you should be able to build this simple 5 component kit. The kit includes the PIC Micro controller (pre-programmed and tested), the circuit board, resonator, heat-shrink tubing and servo connector. You will require solder, servo leads, a soldering iron, and heat gun (to shrink the included heat-shrink tubing)
- Servo Reverser
- (Shipping early June, 2002)
- This is the latest addition to our product wish list. It will allow for single channel control of 2 servos for ailerons. It is microprocessor controlled and includes a "Y" cable for connection to 2 servos.
- Exponential Adaptor
- (Now Shipping)
- This product will revolutionize the experience of learning to fly R/C. With this inexpensive unit installed in your trainer aircraft, you get exponential control of your servos. This helps eliminate tendency to over-correct when learning to fly. This unit is also ideal for the more experienced pilot who wants to fly higher performance planes without purchasing expensive computerized radio gear.
- Glitch Filter
- (In Development)
- The two channel glitch filter is a simple device, built on the same microprocessor and circuit board as our Exponential Adaptor. This filter simply looks for erroneous signals from your receiver to your servos, and removes them. It is not recommended for highly aerobatic modeling, but for slow and park fliers, it will smooth out those bumps, especially when flying in a local school yard where stray signals can wreak havoc with your radio gear.
- The Armor
- (In Development)
- Bill-Tek is working hard to make your modeling experience enjoyable. This product is being developed to give some of you with older, or even brand new, PPM type radios one of the features that sells PCM radios. With "The Armor' your model becomes far more difficult for stray signals to "shoot down". Check the page out for more detailed information.
